Originally Posted by
MikeXray
Yes, its very free, as free as a bearing should be, valls brought up a good point, maybe you have a new batch of knuckles, or a bad batch? remind me on sunday and will give you 2 that I have that are older and see if it makes a difference.
no I have old one from XXX-S (graphite) and new one EA3, I also have one that I borrowed from you at Jackson. they are all same it's not on hub, just look at the picture of it.
they drilled the axle too close. they drilled it closer than the XXX-S CVD, with XXX-S we only had to run 1 washer, never had any problem, with that much closer you can not run a washer, are you coming to SI this sunday? that s where i 'm gonna be at.
Originally Posted by
lidebt2
Did you ever think it might be 'just' John and not the knuckles??????
no Blue, with a brand new hex my wheel spins fine, after few run it get grindy, or locked. LCD, RCD all same.