Originally Posted by
MonkeyFist
Ok guys I'm assembling my JRXS and I got to the point of putting the front end together. I used the heat shrink to hold in the pin on the drive axles in place. I was stunned at the amount of plastic I was going to have to cut away for the axle to fit though the castor block. Is there a trick I can use instead of the heat shrink tubing? Would shoe goo do the trick? Or am I left with cutting the castor blocks.
no no no ....you dont have to remove too much from a castor block. just about 2mm. just make sure you trimmed the shrink tubing in right length. the shrink tube just have to go over a pins, no longer than that.
bielive me shrink tubing is da BEST.