Originally Posted by
cosmo1974
I just wanted to double check the timing advice.
I am now running an LRP SPX on profile 7 (with the Trinity Duo 10.5T brushless).
Should I advance the motor timing above zero, or just rely on the speedy firmware to advance the timing ?
?
Note that heat should not be a major issue as I have a heatsink & fan on the SPX, and a fan on the motor (can never be too careful). Most of the other SPX drivers are running an FDR between 6.2 and 6.5 (big flowing 1000' track).
Thanks in advance
Yea, start with the middle hole for timing. Just keep an eye on temps and you should be fine.
-Korey