R/C Tech Forums - View Single Post - Anybody ever thought of this?
Thread
:
Anybody ever thought of this?
View Single Post
08-13-2009, 08:56 PM
#
3
jrwoodchuck
Tech Master
Join Date: Nov 2007
Location: Northampton, Massachusettes
Posts: 1,336
Trader Rating
: 0
with a "set screw", the clutch would only have one small point holding it on. with the "collet" there is a full 360 degree clamp around the shaft. the collet will hold much better. Plus you have to run a clutch with a engine.
Reply
jrwoodchuck
View Public Profile
Find More Posts by jrwoodchuck
View iTrader Profile