Thread: hex tools
View Single Post
Old 08-08-2009, 03:59 PM   #14
jpz_67
Tech Master
 
jpz_67's Avatar
 
Join Date: Jul 2006
Location: Texas.
Posts: 1,791
Trader Rating: 56 (100%+)
Default

Those eds tools do look nice. I use a lot of torque when I tighten a screw, sometimes to much. The mips are the only tools that seem to be able and handle the load. I know this sounds severe but with other wrenches that have a setscrew holding the tip in the handle, I have actually had the setscrew dislodge itself and also pull all the threads out with it trying to remove a screw!
I never strip a screw out either, you wont find any dremel marks on my buggy.
__________________
TKI4, Futaba, Nitro Pro Fuel, Protek, Proline.
jpz_67 is offline   Reply With Quote