So here some pics of getting the smc 40c to fit.
Well, here's a pic of my car now. After all was done.
1. As you can see in this pic I dremeled some the top deck there so the wires could come up through.
2. Install the FlyingFox layshafter. As you can see in pic where the blue tape is I added to show where the battery end is.
3. Had to grind down the rear bulkheads/screw some to accommidate the height of the pack.
4. Now I ground down some the plastic in the back of the pack too, but do that at own risk. Be careful. Blue tape is the spots ground. This pic shows the lipo tray modified to fit.
Or, if I was to do it again. I would probably get the TP packs. lol. O well, it's down and is fine.
