Originally Posted by
sperera
Sorry I am new to this but where exactly is the head? Is this the area directly next to the glow plug? Or do I measure it on the side under the head sinks? where there are smaller heat sinks cast into the body of the engine?
Stupid question I know but again this is my first one.
no stupid questions, just the people asking them
lol JK JK JK, everyone is new at one point, i just wish i knew about rctech when i started racing.
the head is the cooling head, its the part about the block of the engine, there is a hole where you put the glow plug into, thats where you temp from, NOT from the side
the picture is a cooling head, you point the temp gun straight down the BIG hole between the C6 and the RB. not the small 4 holes. its the same place on all engines, Does this help?