View Single Post
Old 07-06-2009, 06:06 AM   #9416
caltek1
Tech Elite
 
caltek1's Avatar
 
Join Date: Mar 2007
Posts: 3,403
Trader Rating: 36 (100%+)
Default

redbones,

My front and rear shocks use three hole piston and built as per the M chassis TRF instructions with the o ring under the piston. I use 50wt oil front and 40wt oil rear. I have fitted yellow TRF springs front and rear. Length as per instructions.

I have the collars wound down approx 2mm front and rear. I still haven't measured my ride height. I will revise post when I do later.

I ran the kit again tonight in the cold and found that I needed to run softer front and rear tyres fitted with softer inserts. The car was again stable with no traction roll issues. Poor choice of tyres induced rear sliding out. Easily fixed by tyre change.

My kit is built as a MO5L.

Regards,

Calvin.
caltek1 is offline   Reply With Quote