Originally Posted by
dash riprock
I just replaced mine yesterday and one trick I used to make it much easier was to dab some fuel on the outside of the tubing.This made the tubing slippery and it slid right into the hole in the tank.Then with a long pair of needlenose finish pulling the fuel line in and then out of the filler hole.You can then install the clunk/filter on the end of the tubing.Pop the clunk back in the tank and pull any excess tubing back out of the tank.Once the fuel has evaporated the tubing is nice and snug in the tank.
Also, you can trim the outside edge of your fuel line so when you first try to get it in, it fits easier. Just like the Losi clutch pins. Then once you get it in cut the trimmed part off.