Originally Posted by
Ffejdat
John St Amant and others- Did you ever find any issue with the front end, where was the problem, which part staightened things out, etc... haven't followed this thread for awhile, just wondering what the latest was on this, one part bad, operator error, wrong assembly, etc... Just wanna know what to look out for, THANKS!
Looks like the upper arm and the plastic heim joint with pivot ball were the culprit. the hole was not straight in the part but looked good during installation.
The only way to fix it was to get lucky and find ones that are right right out of the package. Looks like most if not all the new ones are good to go. You would be hard pressed to tell with out attempting assembly.