R/C Tech Forums - View Single Post - Bent manifold and best way to bend it back?
Thread: Bent manifold and best way to bend it back?
View Single Post
Old 05-08-2009, 08:41 AM
  #6  
markr04
Tech Regular
iTrader: (1)
 
markr04's Avatar
 
Join Date: Jan 2009
Location: TX
Posts: 421
Trader Rating: 1 (100%+)
Default
Originally Posted by Integra
He's talkin about the header being outta shape...Not the pipe itself.


markr04...i use the ends of a pair of plyers with the rubber handle's and use the edge of the table to get them both sitting level...ive found some brands like to get out of shape A lot easier then other's.
Rubber pliers handle... why didn't I think of that? That sounds a lot better than the screwdrivers I've been using. The screwdrivers have been putting bumps in the manifold, lol.

Thanks.
markr04 is offline  
Reply