Hi Joe,
I was hoping to get this clarified. I have a couple of 4.0t along with the optional rotors (type 1, 3, 4). From the posts to date, the version I have is V2 or V1.5 (depending on what classification system is used)
V1/V2/V3
or
V1/V1.5/V2
Timing:
Is the centre mark (long dash) = zero degrees timing and is each mark approx. 4degrees?
My motor from factory was set as shown.
Is this correct? as that would indicate it is set at approx 10degrees of timing (positive/advanced)
Thanks,
Leonard.