Hi guys, Andy, I need some advice on foam trimming. I just picked up a new set of 2.2 Goosebumps front and rear (man the rears are hard to get a hold of...
). I have very little experience trimming foams since just recently got back into the hobby and in the old days there were no foams...
So basically I have no problems trimming the inside edge for fitting to the rim. But what I was wondering is about trimming the outside edge to fit the natural curve of the tire?
Do you guys do this to your goosebumps? Or do you leave it square. I'm wondering what this will change on the tire itself.
Any help/advice with this would be greatly appreciated.
Cheers!
CODMAN