Originally Posted by
redbones
mm, dont have pics atm, but it is very simple. when you take the arm side off the servo saver, you will see that the outer 2 springs are not flush with the molding. rotate the spring so that one side is flush and you will see how much play there really is on the other side. Simple cut a piece of thin card board (like the one from the tamiya packaging) and fill that space up. I used about three layers folded like an accordian. Hope this helps.
btw, anyone have the clearance between the top and bottom plates? don't have car atm.
Thanks for the tips, will try it soon,so far I havent got the slack problem yet (knocking wood) and I just replace the front part to Square one. I think its 25mm from top deck to the chassis.