Originally Posted by
losi_racer
ok, i have an os vspec, long story short
conrod blew after 3/4th of a gallon,os replaced the conrod but not the piston and sleeve that was damaged, SOOOOO
i was able to pick up the speed piston and sleeve for cost and im picking that up friday.
but i wanna know whats the BEST break in procedure. i did the heat cycle, but i think i did it wrong
i do plan on gettin a speed conrod AFTER breakn so this doesnt happen again
for breakin, get a hudy bench, we use two at a time, well worth the money.