R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 10-14-2003, 01:33 PM
  #4397  
stormperson
Tech Master
iTrader: (1)
 
stormperson's Avatar
 
Join Date: Sep 2001
Location: MA
Posts: 1,185
Trader Rating: 1 (100%+)
Default

racerdx- You might have one of the following problems:

-sidelinks: They could be binding or uneven, and that could cause your problem

-springs: you might have a bad spring, if you havent replaced them recently it cant hurt.

-end points: make sure that you are not combing end points and tweak, since that will defently mess you up.

-bearings: make sure all of your bearings are fine, since that might be the problem or contributing to it

-diff: i dunno if it will do what you are saying, but it could be hurting something, so check that as well

Also you sure you tweaked it properly? You used a flat surface, went very slowly when you raised the car and neither front wheels were binding? (since sometimes if a bearing is bad or the wheelnut is too tight, it can seem like the car is off tweak).

LMK if these suggestions help.
stormperson is offline