Originally posted by markp27
Another question for you guys:
When I take a hold of the wheels (front or rear), I can pull and push them out sideways about 1 or 2mm. It seem the dogbone adaptors are too long - it this normal (without the wheels it's the same - 1 or 2mm sideways movement, so it's not that the wheels are loose)
Cheers, Mark.
1 or 2mm seems a little bit much to me. Maybe it seems so but I canīt believe itīs really that much.
Iīm using just one of the thickest 5mm shims on each wheel axle. I think the thickest shim is 0.3mm and goes between outer bearing and the 2mm pin.