R/C Tech Forums - View Single Post - What is the average increase in run time by dropping from an 8 to 7mm carb insert?
Thread
:
What is the average increase in run time by dropping from an 8 to 7mm carb insert?
View Single Post
01-21-2009, 09:15 PM
#
3
jrwoodchuck
Tech Master
Join Date: Nov 2007
Location: Northampton, Massachusettes
Posts: 1,336
Trader Rating
: 0
all depends on your finger.... i run a 8mm insert with a v-spec and i can get better run time than some guys with a 6mm insert in same motor, pipe, car combo. it's all in the finger.
i'm trying to hit 500..
Reply
jrwoodchuck
View Public Profile
Find More Posts by jrwoodchuck
View iTrader Profile