R/C Tech Forums - View Single Post - High Idle after WOT
Thread
:
High Idle after WOT
View Single Post
01-20-2009, 08:48 PM
#
12
Tree
Tech Fanatic
iTrader: (
8
)
Join Date: May 2006
Location: Murrieta, California
Posts: 839
Trader Rating
: 8 (100%
+
)
I would set the needles back to factory settings. Check the idle gap. Make sure that it is no more than 1mm when neutral. Once your idle gap is set retune your mill for performance. If you are still having problems you might have a leak somewhere.
Reply
Tree
View Public Profile
Find More Posts by Tree
View iTrader Profile