R/C Tech Forums - View Single Post - How Much Would It Cost To Fully Re-build a VZB V-Spec?
Thread: How Much Would It Cost To Fully Re-build a VZB V-Spec?
View Single Post
Old 01-14-2009, 08:19 AM
  #8  
ABURTON
Tech Elite
iTrader: (24)
 
Join Date: Aug 2007
Location: Birmingham Alabama
Posts: 4,835
Trader Rating: 24 (100%+)
Default
I was looking around when you posted this to see what you would have to get. If you need bearings, p/s, then you gotta get a crank. With the spec after that much running I think(not positive) that the crank pin eggs out.

I posted you some codes below from www.carolinasrc.com should get you a brand new mill for $270 shipped if you use the coupon.

Personally I run the GRP tuned 21's but I would not get into a used motor for that much so maybe look into getting the new one. Hope this helps


If your Order is Between:You Saveiscount Code:
$100.00 - $199.99 $7.50RCJAN97
$200.00 - $299.99$15.00RCJAN915
$300.00 - $699.99$30.00RCJAN930
$700.00 + $65.00 RCJAN965
ABURTON is offline  
Reply