Originally Posted by
rearviewmirror
Thanks! I will give it a try. It just didn't feel right forcing the pin at that angle, but it makes sense.
[IMG]The bolts will pass through, its the toe that angles the bolts, so it looks crooked, but the plastic will flex for it to work. We are using the -1/3 rear toe block with the front centered bushings. Take bushing out, run the bolt though, then install the bushing onto the bolt and press it into the front AL support and install the nut.[/IMG]
Which back plate gives -1/3? What made you run this setting? I was following the Mugen Setup sheet to get a baseline.
We based our settings off of Kenji Osaka's Futaba track setup:
http://www.mugenseiki.com/images/mbx...-eko_tract.pdf
If you have the newer kit, your closer to this setup than the older kit. Diffs 5/7/2, unlike what's on the setup sheet.