Originally Posted by
Slapmaster6000
I haven't had a Serpent S120 in my hands yet. The proto pic's I saw appeared to have copy of my design.... so I expect you wont need one. But incase that it doesn't come with a thrust bearing, then I could recommend one if I get the spec's from the axle. Just in case it's metric, let me know that axle diameter, the threaded stud diameter and the length the axle sticks past the hub bearing. This pic shows the axle is .130" past the hub bearing as an example.
Brian
Ok, Mr. Bodine!!
Here are the measurements you asked for on the Serpent S120.
Axle diameter = .25"
Threaded stud diameter = .157"
Length the axle sticks out past the hub bearing = .030"
What do you have that will fit?