R/C Tech Forums - View Single Post - Losi 8ight 2.0 parts on 8ight-T
Thread: Losi 8ight 2.0 parts on 8ight-T
View Single Post
Old 12-16-2008, 03:56 PM
  #20  
TIX
Tech Master
iTrader: (17)
 
TIX's Avatar
 
Join Date: May 2008
Location: Melbourne Australia
Posts: 1,974
Trader Rating: 17 (100%+)
Default
Originally Posted by Integra
Tix....ill put my foot in my mouth for ya...you are Right....I JUST today did a 2.0 tray in buddy's 8T....there is barely any clearance with a Hitec 5955...BUT you do not have to run 2 washer's...you can shave the chassy about a MM and it clears just fine.....the 1.0 brake rods worked with trimming the fuel tubing down a bit....and the dirt guard definatly needed trimming.

PS yes i do have a Tuned flex on my new 2.0
id rather run 2 spacers than file down my chassis.
i am also running a tuned flex at the moment anyway so i dont have a problem on that chassis

I only noticed the problem with the old chassis because i have bought all the new 8 2.0 parts for the SC8ight CORR truck i am building using my old 8T chassis and 8B parts
so i was fairly pissed when it didnt fit
TIX is offline  
Reply