DROOP
Usually, there are a few way to get Xnumber over ride height (all basically the same idea)
1. set ride height...the usual way...with a ride height gauge.
2. begin setting droop, lift car on whichever side you are setting droop on, life until the tires just start to come off.
-turn the droop screws until the desire droop setting is established.
-keep doing step 2 until desired goal is achieved.
it's super easy...
time permitting somtimes after the first two step...i would use droop blocks to get the equivalent number off the block and mark my setup sheets, this also might help with identify if something is tweak'd.
just my process.....quite a few people do it differently.