Get you a
ENGINE.. the only CNC options you should get for the truggy is the steering knuckles and rear plate (3t2s). The upper bellcrank would to nice also, but the new reinforce plastic upper bellcranks are solid
After trying everything here an there... I only use the steering knuckles and upper bellcrank on my BCE Matrix TR. I run all the plastic holders and plates, but I do use the cnc rear toe plates as a set-up option.
I finished every qaulifier and main this race season with my truggy, so the parts are solid. Just take your time, an pay attenion to the
little things. If your engine is running right your
always in the race