TEKIN RS PRO
what settings are you using for 10.5bl & 6.5bl in 12th car?
For a 10.5
50% drag brake
60% brake strength
0 neutral width
4 throttle profile
90% timing (any higher and the motor cuts out for up to 15 seconds after a knock as I found to my cost this weekend
)
I run the motor with its timing ring at minimum on 57mm/rev, but some advance it halfway and gear it at 54mm/rev. Speedo settings remain the same.
For my LRP 6.5 with a 12.5mm sintered rotor
0 drag brake
60% brake strength
0 neutral width
3 throttle profile
85% timing
Hope this helps.
