Originally Posted by
Akhor
Can you do this with any drive shaft or only the 808?
Not sure. My Kyoshos did. However I am not quite as excited as I was originally. I didn't know Hudy and Xray are related. So the pins are exactly the right size for Xray -and also 0.1mm too big for Kyosho! But still, I can push mine out and turn them 90 degrees and push them back in for a new round surface to drive the cups!
Plus I had a bent shaft that had basically new pins in it to use on another shaft with worn pins. I'll have to decide in the future if it is that money saving to do and maybe I'll drill out my shafts to accept the Hudy pins as there seems to be enough room in the drive cup slots to accept a 3mm pin.
What car are you running?