Originally Posted by
bmmer701
i'm not sure but i think my droop over ride height in front is 2mm and in the rear is 4mm.
here's my setup
front
#1 shock position 35 shock oil 3 holes hara black
2.75 shims in front front of pivot block (2.5 pivot block)
1.0mm under FF blocks
1.5mm under FR blocks
2.0mm under the camber link #2 position (the inner one)
2mm ackerman
camber 3.5
ride height 5mm
droop 7
no stabs
rear
#5 shock position 30 shock oil hara black
2.75 shims in rear rear of pivot block (1.5 pivot block)
1.5mm under RF and RR pivot blocks
1.0mm under the camber link #2 position (inner one)
.75mm in shims in front of the rear hub
2mm in rear of the hub
camber 2
ride height 5mm
droop 5mm
no stabs
using sorex 36 tires and soft inserts.
i'm having understeer onpower and a little bit understeer off power
hehe i'm thinking of standing the shocks in front, or stand the shocks in the rear 1 hole, or just put the 1 deg rear toe hehehe...
btw, i'm running mod 3.5 orion motor and orion 4800 lipo.
Thats my set up
front:
number 2 shock position and 40w oil , 3hole piston.
1mm under FF block
1mm under FR block (what korey recomended me and its much better then before)
2mm under camber link , 1st position
camber , 1.5
ride height 5mm
droop over ride height 2mm
ackerman 4mm
rear:
number 3 shock position and 40w oils 3 hole piston
1.5mm under RF block
1.5mm under RR block
1mm under camber link , 1st position(what Korey told me wich is also better then before, my rear end isnt tail fishy as before)
camber 1.5
ride height 5.5mm
droop over ride height 3mm
I run 5.5 BL , 5 cell .
Hope that helps.