The setup was something like this:
Front
Yellow spring,
400wt tamiya oil,
2 O rings in the shock bladers,
Shock tops in middle hole on tower,
Blue roll bar,
Camber link in inner upper hole on tower,
One way diff,
4.5mm ride height,
2 degrees of camber,
Droop was set with drive shafts just above level,
Wheel base was as kit but with 1mm spacer at the back of the front arms
0.5 degrees toe out
Rear,
Yellow spring,
400wt Tamiya oil,
2 O rings in the shock bladders,
Shock tops in middle hole,
Blue roll bar,
Camber link in lower inner hole,
2 degrees of camber,
Droop set with driveshafts just below level,
C rear toe in block
Outer link on the toe blocks,
Vectra shell,
Take off CS22/27 Tyres with std inserts,
Think thats about it.
Rick