Originally Posted by
SteveJa
ok so is that 2mm front and 2.5mm rear or 2 or 2.5 front and rear? also do I measure right under the a-arm parallel with the wheels ? because you will get different measurements depending on where you measure.
Thanks
this helps alot.....
this is how i measure the droop on tc as well.screw the droop screws flush inside the arm.all 4 corners.get your ride height front and rear.say if you were racing rubber tire then say it would be 5mm droop front and rear...so then if you run 2mm of droop front and rear you set the chassi on the 7mm ride height gage.screw the droop screw down untill the tire lifts off the table.back it back down untill the tire rests on the table...do the same on the other side and the rear....just make sure that your shocks are the same lengths.and that you use the ride height gage at the same area.
if i can help any other way pm me.
i used a losi type-r car last year...but i am really considering of trying the tc5r...so thats why i was checking in on the forum.
hope this info helps.
matt