hi what do u think off this
a friend of mine is an engineer and has done theese parts for me brongs motor in line and lowers the spurgear 5mm made out of t6 aliminium
any questions just ask
Looks good. Also looks like it moves the motor inward about 4mm (since it doesnt have the extra motor mount piece). I assume you have to drill a new hole or 2 in the chassis to support that. Only problem I see if you would have to remove the bulkheads to change the spur gear. If people switch between classes often that would probably be a deal breaker. Pinion changes also look difficult since it covers the hole on the bottom of the chassis for changing pinions. You would probably have to take the top deck off to change a pinion.
Rear diff is in backwards in the picture. How well do the belts fit with this mod?