Hi, just finished putting on my ofna shoes (10011) with the black springs and had to shim the flywheel bolt once becasue the springs were are to extreme an angle to work proper. Im guessing at full speed the springs would fail and pop out of the groove. Anyway, so after putting it all back together, I read that the CB (clutch bell) needs to cover the shoes completely, yet after the shimming, the CB can no longer do that! If I shim the shoes up, then the shim I did for the nut was for nothing.
Here is a pic of my finial setup. Is anyone else running the same setup, does this look acceptable, and will work just fine? Everything on the motor is stock except im using HPIs vented racing CB. Please, I need help on this situation.
