R/C Tech Forums - View Single Post - Hot Bodies Cyclone
Thread: Hot Bodies Cyclone
View Single Post
Old 08-08-2008, 06:24 AM
  #13335  
shadow102
Tech Master
iTrader: (21)
 
shadow102's Avatar
 
Join Date: Feb 2008
Posts: 1,441
Trader Rating: 21 (96%+)
Default
Originally Posted by timmaay
ok i have ball studs that fit, but when i shim 4mm the ball ends touch the front pivot and won't allow it to turn. so my question is how do you over come that?

thanks again!
i have the same problem when you go to the outside hole on the rear up rights. what you do is shave off the top of the ball cup just gotta keep an eye on the amount of dirt that gets in there as it will wear out the ball end quicker
shadow102 is offline  
Reply