Originally Posted by
InspGadgt
...I've seen a few of your great wiring jobs here on RC Tech and was wondering...on chassis where you run the motor wires on the chassis, what do you use to hold it there? I've been using the sticker sheets that look like graphite but I haven't really been happy with that.
The nature of the silicone jacket on the wire we use makes it very difficult to attach it to the chassis. It just doesn't stick to anything that well. I've tried ca, shoo goo and epoxy and the best solution is the 5 minute epoxy I have been using. It doesn't stick all that well but better than the others, which the wire peels right off of as soon as it dries. At least the epoxy forms a filet around the wire and holds it in place pretty well.
All that being said, the wires mostly only need to be held in place until the batteries are installed
