Originally Posted by
Juanchoyo
Hi, this is a photo from the TB V MS
http://www.rceasy.com/wp-content/upl...2107photo5.jpg
But this car uses the same suspension parts as 416 and the question is: Do you change rear toe by chagign the alum. long part that holds suspension shafts?? Or change the rear hubs like in a mini? How's this blue alum part named?
Would this ride be really good (416) to run 10.5 and 6 cells? Or I'm better going with TB 5MS?
Thanks
416 works very well in 10.5/LiPo... it's the class I largely run in.
The part you are refering to is the suspension blocks. You'll see them quoted on here as 1D, 1E etc. They are how you adjust toe-in. The hub are 0° toe-in.
HiH
Ed