Originally Posted by
schreff
Fast Freddy, as you already know, the bearings in the original JRXS one-way are backwards from that of the Type R one-way. As far as removing them to swap sides... I'm not sure that can be done without messing things up. They're pressed in there pretty good. I haven't seen any successful attempts at swapping them. You're better off getting a new one-way.
Now, if you do get them out to swap them, more power to ya.
I tried pulling the bearings out of my one way to change them because they blew up... i used a heat gun and a screwdriver, now i have a warped bearing tube AND blowed up bearings ;0.
I picked it up off ebay, it was listed as a jrx-s pro one way, could be why the bearings are blowed up hahaha.