Originally Posted by
xlgraphicspro
I have a Futaba 9351 high torque servo. any way, I turned it on today to practice before a race and it started to shake worse than Micheal J. Fox. I was told they do that when the plastic gear wears out. I replaced that, but it still shakes. It opperated fine when it's on the ground, but in the air is when it shimmies. any idea what causes this? do I have to replace all the gears.
Some servo's will do it with no load, my 9351 does it as do some KO and JR servo's I wouldnt worry about it... it does not effect the buggy even in the air.
It could be a problem for an elevator servo, but i dont think a buggy uses elevator.