With that said, it's nothing major. It is just very crucial like I
said to work the mesh and shimming on helical cut gears. THis type of
gear is very smooth and effecient but may not be as "build and go" as
straight cut gears.
So knowing that most people will simply purchase a kit and just run it
makes OCM a bit hesitant on this issue. I spent a little time with
mine, running it to break things in then I checked it. I shimmed it
properly and put a fair amount of time on it. Not to mention it was a
high bite track that I am positive worked the gears during
acceleration/braking. Same goes for our other three test truck in
Alabama.
We will have a few more of our drivers getting them to test and give
us some more feedback.
Guys, again sorry for the delay but I would much rather deal with
this than other problems!
Thanks!
Alan Burton