R/C Tech Forums - View Single Post - Looking for a few OS .18TM parts
Thread: Looking for a few OS .18TM parts
View Single Post
Old 03-03-2008, 10:04 PM
  #2  
GenReaper
Tech Fanatic
iTrader: (8)
 
GenReaper's Avatar
 
Join Date: Jun 2007
Location: Adelaide
Posts: 895
Trader Rating: 8 (100%+)
Default
http://www3.towerhobbies.com/cgi-bin...&I=LXHKW1&P=OW

http://www3.towerhobbies.com/cgi-bin...&I=LXCC94&P=OW

http://www3.towerhobbies.com/cgi-bin...&I=LXJPZ5&P=OW

You may want to enquire about that backing plate as it is for a TZ and if you grind the nub off your crank it may work but you need to make sure piston clearance it alright.
Pretty sure its pull start only, tho you could cheat and take the backing plate out, press or drill the brass bushing out, get it alloy welded and remachine the face where the con rod sits against.

http://www3.towerhobbies.com/cgi-bin...=OSMG2112&P=OW
Last edited by GenReaper; 03-03-2008 at 10:14 PM.
GenReaper is offline  
Reply