Originally Posted by
TryHard
So then...
Did get too one point where it made the rear of the car too snappy, but managed to solve that by dropping the rear RC a little.
Good thing was, no big breakages, only slight issue is when I got home I noticed a slight bit of delamination on the chassis plate under the motor. Was only about 10mm long, so borrowed some epoxy resin from work, and patched it up last night. I love working in a composites company...
Regards
Ed
when you say the rear was snappy, do you mean it would fishtail a little? cause i would think that raising rear rc would have helped?
would you attribute the delamination to? motor heat? impact?
thanks