Originally Posted by
redbones
Found out something lame.
If you use the short reversible arms on the rear, the right side will have problems. The plastic dog bone protector will hit the diff nut and you can't adjust your camber to spec. You can try to use a wider suspension mount, but you will then be limited to about 1degree of rear toe in. Unless you have a 42mm dog bone (53502) it won't work
BTW, the short sus arm has no slop what so ever. The shaft sits tight into the arm. What happened to you tamiya?
I just used a knife to remove some material from the blades and it's fine!
Also, remember to squeese the diff spring a couple of times before you install it. This will make it shorter and make up some room for the blade.