R/C Tech Forums - View Single Post - Schumacher Corner
View Single Post
Old 12-03-2007, 07:49 PM
  #23579  
Customworksking
Tech Elite
iTrader: (74)
 
Customworksking's Avatar
 
Join Date: Oct 2004
Location: Springfield ILLINOIS
Posts: 3,665
Trader Rating: 74 (100%+)
Thumbs up

Originally Posted by MagicMarker
Alright Guys got a question for you. First, I run mainly carpet foams and have been talking to a few race buddies about the diff height. I feel that the lower position on the diff would be best for foams and the upper / higher position for rubbers. However, I have had a buddy tell me otherwise and had me look at Goetz's setup. And there it was the diffs in the higher postion, so what does diff height do? I know I should know this but I think I have it all screwed up. Thanks guys.

L8R Marker
it changes the roll center U will want to try this 1st I also run foam/rubber and ran foam last weekend I ran the frt diff high rear low lower the diff more bite/roll ...If u find you car good the 1st few mins of the race hooked up and loose at the end the frt bite is up so u need to take some out,run it high and a sway bar worked for me and well Drew Ellis ran his frt diff high as well..
Customworksking is offline