Originally Posted by
rinkrat99
AdrianM
After installation of the flat servo usingf the middle holes of the saver, should the angle between the ballstuds and the saver be;
1) Slightly angled down from ballstud to saver
2) Parallel to chassis
3) Slightly angled up from ballstud to saver
Thanks
Snag with all of these questions and answers is that it will change when you adjust yer ride height. I've just been buggering around with all this and found 1mm ride height adjustment throws all that work out with the bath water. Damm and blast. So now I'll hunt the compromise or just work harder so I can afford millions of front wheels so I can just run one size !!
Strooth !!
Jacko