Originally Posted by
andrewdoherty
. . .and correct me if I am wrong, but the 2408 diff rings have experienced a running change and no longer need sanding out of the package. I just built four diffs with them and they were super flat. They look machined to me now instead of stamped. I couldn't find a round edge on them at all. I think I remember reading adam said they had sold out of all the older style 2408 rings and they were all the newer style now when they come from Schui USA
jay-
we ran a 10.5 class sat and we were mostly around 5.2-5.6. For reference we run on a large piece of carpet and were running 13-14 second laps. I might start at a 5.9 and temp and gear up accordingly. This was all with an LRP sphere comp, orion 4800, the novak 10.5/4300's with sintered rotors. I wasn't running a fan at all and temps indoors were low
80's. I was running a 32/96 with 57 mm tires and my motor didn't get over 130.
You're absolutely right on the 2408 diff rings, they're not stamped but I took some 800 grit sp to 'em anyhow.
Our lap times are very similar with a rare high-12 lap thrown in. With my LRP13.5 today in practice I threw down quite a few 13.7sec laps (which is actually quite faasst
)
Thanks brah...here's a few pics of the Core in my car w/the SP9.5R......