Outdoor Set-up
Hey guy's,here is a set up I think you might want to try if you race on a medieum traction track or parking lot.If you try it let me know what you think,and if you got something else in mind lets start posting set-ups and compare.
Thank's,
Brian Jucha
Front:
Oil:70wt
piston:54/ limiter's outside-.118 inside-.060
Spring:silver
droop:6(measured off the arm)
roll center block:high
pivot support:OF
sway bar:.063
shock location:hole#4(all the way stood up).060 spacer under bellcrank ball stud
caster block:4
camber link:drill hole above & between #2&3
Ride height:5mm/camber 1/2 degree
oneway front diff
Rear:
Oil:40wt
piston:54/limiter's outside-.080 inside .030
Spring:silver
droop:4(measured off arm)
roll center:Mid(cut .060 off high blocks or shim up a low roll block)
pivot support:4R in upper hole's(this will give 1-2 degree of anti-squat)
shock location:hole#4(all the way stood up)
camber link:3-B-use standard silver ball end
arm spacing:middle F&R
ride height:5mm-camber:1/2 degree
Tires:Takeoff CS-27
Last edited by BrianJ; 05-13-2003 at 03:37 PM.