Originally Posted by
THE DARKSIDE
Crap, I'll get some out to you. The jig uses stardard 4-40 screws that are about 5/8" - 3/4" long. I will usually build the link and attach one to the block and screw the link close to the proper length. At that point, I will attach the other link end and gradually tighten it down to the block while adjusting the overall length to the point were it is pretty close to the correct length.
-E
Do you find it better to have the 2-56 screws loose or tight when adjusting? Once both ends are in you tighten it until when? Until it's it's tight?