Originally Posted by
POOKYT
Its pretty much like NO other CV axle. Take your time and use a dab of white grease on the axel and bone where they meet. The parts then slide together. The toughest part is getting the shrink centered before you heat it. You want to make sure the pins are covered but you don't want much if any excess hanging off the ends. Most of the time you will have some excess so just use your X-Acto knife and trim it off even with the edge of the coupler. Good Luck.
Brant
I just take the piece of shrink they give you cut it in half, center it on both and heat it up. Some will hang off both sides. Once its shrunk take a sharp exacto and cut the shrink right along the cylinder part on both sides. Then heat slightly again to get it to tighten up slightly more. Then your ready to have NO chatter.