Has anyhone else noticed that when you set the rear toe in according to the manual (every 0.5mm washer is approx 0.6 deg) you actually end up with more than it says
I used the 1 deg rear hubs and removed the 0.5mm washer from the rear pivot block, this should have given me 2.4 deg of rear toe (with the rear 0.5mm washer in place the car should have 2 deg rear toe, remove that then use the hubs, 2 deg - 0.6 deg + 1 deg = 2.4, however, when I used my toe guages I actually have closer to 3.2 deg!
Is there something abvious I'm misreading or will I need to get the gauges out everytime?
I haven't yet used the guages to measure the standard settings.
***Does the kit setup provide 2.4 deg of rear toe?
Skiddins