Originally Posted by
aus jd 2703
hey on the ec can u run the front hinge pins with no shims and no spacers at all just flat on the chassis?
also can u run 3mm of shims plus riser in the rear?
cheers
You're really going to the extremes there on both ends. I never ran the blocks that low in the front but I don't think you can do it because the arms will rub on the chassis. You shouldn't need to go that far. Same in the rear. You shouldn't need to go that far with the roll centers. At the most, go to only 1mm under the front blocks.
Try using pin angle to get the steering you want like I suggested.