R/C Tech Forums - View Single Post - Hyper 7 PBS front assembly question
Thread: Hyper 7 PBS front assembly question
View Single Post
Old 06-05-2007, 10:22 AM
  #3  
Nickmind
Tech Regular
iTrader: (5)
 
Nickmind's Avatar
 
Join Date: Jan 2006
Location: San Diego
Posts: 388
Trader Rating: 5 (100%+)
Default
Originally Posted by MADMAN23
for the top pivot ball leave it out a 1/4th from knuckle... for the bottom screw it in till you dont see any thread....
knuckle is the flat unthreaded part of the screw?

Thanks for your help. I have had this question on OFNA website for a week without reply.

Thank again.
Nickmind is offline  
Reply